View Artikel Ilmiah
Kembali| NIM (Student Number) | G1G008002 |
|---|---|
| Nama Mahasiswa | MAHINDRA AWWALUDIN R |
| Judul Artikel | UJI STRAIN IN COMPRESSION, SETTING TIME DAN REPRODUCTION OF DETAIL TERHADAP ALGINATE IMPRESSION MATERIAL HASIL SINTESIS MODIFIKASI BAHAN PENGISI |
| Abstrak | Bahan cetak alginat sampai sekarang masih banyak digunakan di Kedokteran Gigi dengan alasan penanganannya mudah, alat yang dipergunakan relatif sederhana, elastis, cukup akurat apabila penanganannya secara tepat dan relatif lebih murah. Tujuan penelitian ini adalah menguji strain in compression, setting time dan reproduction of detail terhadap alginate impression material hasil sintesis modifikasi bahan pengisi. Metode penelitian yang digunakan adalah metode eksperimental laboratoris. Sintesis menggunakan bahan-bahan kimia yang beredar di pasaran Indonesia. Pengujian strain in compression menggunakan alat uji kekuatan tarik Mesdanlab Strenght, pengujian setting time dan reproduction of detail menggunakan alat ukur kedalaman yang dimodifikasi. Data yang diperoleh untuk strain in compression optimal sebesar 1, 353 N, sedangkan standarnya adalah 0,37-0,69 N/mm, setting time yaitu 03:37,14 s, sedangkan standar fast setting (1-2 menit) atau normal setting (2-4 menit). dan reproduction of detail yaitu 9,25 mm. Penelitian selanjutnya diharapkan menggunakan material dengan kualitas bagus dan mempunyai media penyimpanan yang tepat agar tidak terkontaminasi, komposisi yang tepat, meneliti karakteristik alginate impression material yang lain yaitu working time, recovery form deformation, compressive strength, compatibility with gypsum, deterioration dan dimensional stability. |
| Abstrak (Inggris) | Alginate impression material are favourite used in dentistry because easy to handle, the tool used is relatively simple, elastic, more accurate than non elastic impression material and reatively cheaper. The purpose of this study was to test the strain in compression, setting time and the reproduction of detail of the alginate impression material synthesized modified fillers. The research method used was experimental laboratory. Synthesis using chemicals on the market in Indonesia. Strain in compression testing using a tensile strength tester Mesdanlab Strength, setting time and reproduction of detail using a modified depth gauge. The result were obtained for optimal strain in compression of 1, 353 N while the standart is 0.37-0.69 N/mm, setting time is 03:37,14s while setting the standard fast (1-2 minutes) or normal setting (2-4 minutes) and reproduction of detail that is 9.25 mm. Further researcher are expected to use good quality materials and have the appropriate storage to avoid contamination, the exact composition, examines the other characteristics of alginate impression material such as working time, recovery form deformation, compressive strength, compatibility with gypsum, deterioration and dimensional stability. |
| Kata Kunci | Alginate Impression Material, Setting Time, Strain in Compression, Reproduction of Detail |
| Nama Pembimbing 1 | Prof. Dr. Ir Bambang Sunendar P., M. Eng. |
| Nama Pembimbing 2 | Dr. drg.A.Haris Budi Widodo, M.Kes.,A.P.,S.IP |
| Tahun | 2012 |
| Jumlah Halaman | 12 |
Page generated in 0.0546 seconds.